Setting up the hardware:

Step 1: Connect the power cable to your SPA-1001

Step 2: Connect the network cable from your SPA-1001 to your DHCP enabled modem/router

Step 3: Connect an analog phone to the “Phone” port in the SPA-1001.

Step 4: Turn the power on

Step 5: Pick up the phone and dial **** (You should hear a voice saying Sipura Configuration Menu)

Step 6: Dial 110# (Write down the IP address that is returned)

Section 2 – Configuring the SPA-1001 via the Web Interface

Once you have the IP address of your SPA-1001 you can access the web interface by

opening a web browser and typing the following in the Address :

http:// < IP Address of SPA-1001>

For example: http://192.168.1.10

You should now see the Sipura SPA-1001 Phone Adapter Configuration screen. Now you

will need to log into the unit as Administrator and change the view to advanced. See images below.

Click on “Admin Login”

Click on “advanced”

Note: You can also go directly to the admin/advanced section by typing

http://192.168.1.10/admin/advanced

Auto Provisioning Sipura from Midwest SIP:

Provisioning Tab:

Profile Rule: [--key $B]http://slave.midwestsip.com/$A/$MA.cfg

GPP A: 1

If a tech has asked you to add this information, please add info from above, save configuration then pull the power cord and then plug back in!  Now your device will have all your settings from the customer portal. This may take a few minutes then you should be registered and have a dial tone.

Section 3 – Line 1 or Line 2 Settings

Click on the “Line 1” or “Line 2” tab.

The settings for Line 1 and Line 2 are identical, so for each provider you want to register

follow the instructions below:

The first thing that needs to be changed is under the Proxy and Registration heading. Here

you will need to update the following:

Proxy: sip.midwestsip.com

Then Go to Subcriber information.

Display name: Your name or DID number

User ID: (username or DID from Midwest SIP customer portal or email)

Password: (password from Midwest SIP customer portal or email)

Use Auth ID: Yes

Auth ID:  (username or DID from Midwest SIP email)

Click on Select all Changes at the bottom of the page.

The Sipura will reboot at this time.

Once the Sipura pages comes up, look to see if you are registered under line 1 status.

See also: http://www.sipura.net/support/index.htm

Factory Reset...Only follow these instructions if explicitly told to do so per Tech Support:

To perform a factory reset on your SPA-1001 dial **** on the phone. You should hear a

Sipura message asking you to enter your selection. . Then dial 73738#.

WARNING: This will restore your unit back to factory defaults, all your information will

be lost.

Additional...

to obtain the subnet mask....dial 121#

to obtain the default gateway...dial 131#